Changing The Settings; Factory Default Settings - SHOWTEC Spectral CYC2000 Product Manual

Changing the Settings

1) Enter the ID Mode and select On in order to allow ID address function.
2) In order to reset the custom modes to its default values select REST.
3) Enter UPLD to upload the custom programs from the current MASTER device to all SLAVE devices.
In order to activate the upload function the password must be entered.
Password: UP > DOWN > UP > DOWN.
When uploading the MASTER and SLAVE units will light up YELLOW.
If an error occurs when uploading the MASTER and/or SLAVE devices will light up RED.
When uploading one of the custom programs has been successful, the MASTER and SLAVE devices will
light up GREEN.
4) Enter DIM Mode to select a certain dimmer mode and dimmer speed.
When DIMMER is set to OFF, then RGBW and the MASTER DIMMER are linear.
Dim 1/2/3/4 are speed modes of the non linear dimmer. DIM1 is fastest, and DIM4 is slowest.
The DIM setting doesn not have any effect in TOUR mode.
5) When you have selected RGBW to ON, RGB TO WHITE has been set.
This means RGB = 255, 255, 255. The color is displayed as you have calibrated the specific color in menu
CAL2  RGBW.
When it is set to NO, on RGB = 255,255,255, the RGB values are not adjusted and the output is most
powerful. The RGB' s parameter can be adjusted in CAL2 .
6) When UC is selected, the RGB output is adjusted to a standard preset universal color. This way, different
versions of Spectral CYC2000‟s are color balanced to match each other.

FACTORY DEFAULT SETTINGS

1 STATIC = 000
2 DMX Address = 001
3 Run Mode = DMX
4 Personality = TOUR
5 ID Address = 001
6 ID ON/OFF = ON
7 DIMMER = DIM4
8 COLOR = OFF
9 EDIT = 000
Then press ENTER to confirm your password.
10 FAN = AUTO
11 KEYLOCK = OFF
16