Calibrating The Hoop; Entering The Fabric Thickness - Bernina 590 User Manual

Setup Program
> Touch the icon «Center the embroidery motif».
> To open the embroidery motif at the saved position, set the switch «Restore saved embroidery motif
> To open the embroidery motif in the center of the hoop, set the switch «Restore saved embroidery motif

Calibrating the hoop

The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
•
•
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Calibrating the hoop».
> Use the arrow icons on the display to move the needle precisely to the center of the pattern.
> Accept the needle position using the icon «Confirm».

Entering the fabric thickness

If the fabric thickness, as for e.g. toweling is more than 4 mm (0.15 inch) it is recommended to select 7.5
mm (0.29 inch) or 10 mm (0.39 inch). The thicker the fabric, the slower the embroidery speed of the
machine. When the machine is switched off, the alterations are reset to the default setting 4 mm (0.15 inch).
> Touch the icon «Home».
54
position» to «I».
position» to «0I».
The embroidery module is connected.
The hoop is fitted with the corresponding embroidery pattern.
1