Entering The Fabric Thickness; Activating/Deactivating The Function Thread Away; Programming The Securing Stitches - Bernina 700 User Manual

Setup Program
> Tap «Embroidery Settings».
> Tap «Calibrating the Embroidery Hoop».
> To delete the current calibration, tap «Deleting» (1).
> Center the needle via the arrow icons on the display.
1

Entering the fabric thickness

If the fabric thickness is more than 4 mm as for e.g. toweling, it is recommended to select 7.5 mm or 10
mm. The thicker the fabric, the slower the embroidery speed of the machine. When the machine is switched
off, the alterations are reset to the basic setting 4 mm.
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Entering the Fabric Thickness».
> Select fabric thickness.

Activating/Deactivating the function thread away

To bring up the thread end after cutting and to pull it out of the fabric, the function must be activated. For
embroidery motifs with long stitches it is recommended to deactivate the function Thread Away. If the
distance between the presser foot and the embroidery hoop is too small, the function will not be carried out.
> Tap «Setup Program».
> Tap «Embroidery Settings».
> Tap «Thread Away».
> Activating/Deactivating the function thread away.

Programming the securing stitches

Embroidery motifs are programmed either with or without securing stitches. If an embroidery motif has
programmed securing stitches, they will be embroidered. If the embroidery motif is programmed with
securing stitches, the securing stitches can be removed in the BERNINA Embroidery Software.
The machine recognizes when no securing stitches are programmed and adds them. If no securing stitches
are wanted, they can be deactivated.
> Tap «Setup Program».
51