3onedata NP Series User Manual page 31

Interface Element
Send_msg
Connection control
Disconnection
control
Description
Disable: Disable password verification function.

Note:
When password verification is enabled, only users with "admin"
account privileges can send / receive messages using this device.
The first data sent by the peer server to the device defaults to the

check password.
Verification password is "admin" account password.

If the password is entered incorrectly, re-establish the

connection and then re-enter the password.
The information sent after the device is connected to the peer
server. Options:
Ipaddr: After the connection is successful, send the IP

address of the device to the remote server.
Device name: After the connection succeeded, send the

device name of the device to the remote server.
turnoff: After the connection is successful, no information

is sent to the peer server.
Select how the serial server initiates a connection request.
Options:
Always: Immediately after the system is started, it tries to

establish a connection with the target host and
automatically reconnects the target host after the
connection is disconnected.
Char: Automatically connects to the target host when

receiving data from the serial port.
DSROn: Automatically connects to the target host when

the DSR signal is detected.
DCDOn: Automatically connects to the target host when

the DCD signal is detected.
Select how the serial server is disconnected. Options:
None: Never shut down the network connection

automatically.
DSROff: Automatically shuts down the network

connection when the DSR signal is detected invalid.
DCDOff: Automatically shuts down the network

3onedata proprietary and confidential
Copyright © 3onedata Co., Ltd.
NP Series Serial Server User Manual
24