Rating Label; Efficiency And Btu Output - Pacific energy ALDERLEA T4 LE Operating And Installation Instructions

PLEASE SAVE THESE INSTRUCTIONS
This manual describes the installation and operation of the;
Pacific Energy, ALDERLEA T4 LE and ALDERLEA T4 LE Classic freestanding wood heater.
SAFETY NOTICE: If this stove is not properly installed, a house fire may result. For your safety, follow the installation
instructions. Contact local building or fire officials about restrictions and installation inspection requirements in you area.
Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result
in property damage, bodily injury, or even death.
ALT 4-LE 040523-28

Rating Label

This heater meets the U.S. Environmental Protection
Agency's 2020 crib wood emission limits for wood
heaters sold after May 15, 2020 using Method 28R.
Under specific test conditions this heater has been
shown to deliver heat at rates ranging from
23,200Btu/hr.
Emissions testing was performed by PFS-TECO Inc.

Efficiency and BTU Output

EPA Certified Emissions
LHV Tested Efficiency 1
HHV Tested Efficiency 2
COTE
SIDE
EPA BTU Output 3
Maximum Wood Length
Ideal Wood Length
Fuel
1 Weighted Average Lower Heating Value (LHV) efficiency as
tested using CSA B415 Performance testing of solid-fuel-
burning heating appliances. LHV assumes the moisture is
already in a vapour state so there is no loss of energy
2 Weighted Average Higher Heating Value (HHV) efficiency
as tested using CSA B415 Performance testing of solid-fuel-
burning heating appliances. HHV includes the energy required
to vaporize the water in the fuel
3 The range of BTU outputs is based on efficiency using CSA
B415 Performance testing of solid-fuel-burning heating appli-
ances and burn rates from the low and high EPA tests using
Douglas Fir dimensional lumber.
3
13,500 to
1.9 grams per hour
78%
72%
13,494 to 23,186 btu/hr.
18 inches
16 inches
Seasoned Cord wood
100003978