point ORBIT ONE User Manual page 18

DISMOUNTING AND MOUNTING OF MOP
Step 1: Dismount the mop.
Dismount the mopping module
from the chassis and remove the
mop from the mop holder.
CAUTION
1. Replace the old mop with a standard one to ensure a good cleaning e ect for the
main body.
2. To avoid main body contamination by the sewage, please dismount the mop before
washing it.
3. It is suggested to replace the mop with a standard one every three to six months.
CLEANING THE PARTS OF THE MAIN BODY.
Step 1: Clean the main body sensors.
Use a clean soft cloth to wipe the
charging contact on the back, the
cliff sensor, the LIDAR sensor, the
infrared sensor, and the along-wall
motion sensor as well.
CAUTION
1. Please clean the main body sensor, the infrared sensor, and the charging contact
with a dry cloth to avoid product damage by water.
2. Please use the screwdriver carefully in part replacement to avoid part damage.
Step 2: Wash the mop.
Flush the mop with clean water, and
dry in the sun before using again to
avoid a bad smell due to dust caking.
Step 2: Clean the omni-directional wheel.
Overturn the appliance, dismount
the omni-directional wheel by lifting
it, remove the hair and other dirt on
the wheel body and the axle, wash
the omni-directional wheel, have it
dried in the sun and mount it again.
18