point ORBIT ONE User Manual page 13

POWER ON/OFF AND CLEANING
4. Partial cleaning
If the partial cleaning button is pressed when
the main body is on standby or paused, the
main body will execute partial cleaning in a
square area (1.6m×1.6m) the center of which is
itself and, after cleaning, automatically go back to
its original position and stop.
5. Fault phenomena
If the main body fails in operation, the
ON/OFF button indicator will flash quickly in
red, accompanied by an audible alarm. Please
eliminate the fault as instructed in the
"Troubleshooting" section in this manual.
6.Sleep state
there is no operation in more than 20 minutes, the main body will go to
sleep automatically. After that, it will be out of the control of the cleaning
base station and can be wakened by pressing any button on it or operating
on the App.
7.Automatic dust collection
After cleaning, the main body will go back to the cleaning base station
automatically for dust collection.
8.Reset button
If the main body cannot be started because of button operation failure, try
the reset system. After the reset button (position: page 7), the main body
will be started automatically; after reset, the product will clear the periodic
cleaning setting and the cleaning mode setting and reset the Wi-Fi.
CAUTION
1. It is suggested to enable the cleaning function while the main body is in the charging
position of the cleaning base station.
2. In the case of a low battery in cleaning, the main body will go back to the cleaning base
station automatically to get recharged and then return to the interrupted position to
continue with the cleaning.
3. Before use, please put the table, chairs, and other floor-type articles in order and put away
any power cables or small articles on the floor to ensure smooth movement of the product.
4. When in use, do not stand in front of the main body of the product, otherwise the main
body will fail to identify the areas to clean.
Partial cleaning
Area 1
Area 3
13
1.6m
Area 2
Area 4