Installation Procedures - All Deployments - HP StorageWorks Modular Smart Array 1500 cs Installation Manual

Installation Procedures -
All Deployments
Installing and configuring your MSA1500 cs includes the following steps, each of
which is illustrated in
Note:
Modular Smart Array 1500 cs Installation Guide
Figure 1
Step 1: Review and confirm your
Step 2: Prepare your
Step 3: Install MSA1500 cs option
Step 4: Rack the MSA1500 cs and the storage
Step 5: Install the hard
Step 6: Prepare your
Step 7: Install the HBA in your
Step 8: Prepare your
Step 9: Connect the
Step 10: Power on your MSA1500
Step 11: Configure your MSA1500
HP recommends installing and configuring your MSA1500 cs in the sequence of
steps listed in this guide. There are specific dependencies and if you deviate from
this sequence, you may have to uninstall and then reinstall your MSA1500 cs.
If a supplier is installing or configuring the MSA1500 cs for you, provide them with
this guide and verify that they complete the information in
Worksheets" on page 85.
For information about HP installing and configuring your MSA1500 cs, see
"Getting help" on page
After the hardware is installed and you are ready to configure your MSA1500 cs,
read the information in
then proceed to "Step 11: Configure your MSA1500
and discussed in this chapter:
plans, page 17
site, page 26
kits, page 28
drives, page 35
servers, page 36
servers, page 37
switches, page 38
cables, page 39
cs, page 49
cs, page 53
13.
"Step 1: Review and confirm your plans" on page 17
1
enclosures, page 29
"MSA1500 cs
cs" on page 53.
and
15