Table of Contents
Advertisement
Installation Procedures - All Deployments
Use the following instructions to install each MSA1500 cs and storage enclosure:
1. Use the provided rack template as a guide to indicate where the rails for the
Figure 3: Using the rack template
30
Caution:
To prevent damage and to ease insertion of the device into the rack,
support the weight of the device and keep it level when sliding it into the rack.
WARNING:
To reduce the risk of personal injury or damage to the
equipment, be sure that:
The leveling jacks on the rack are extended to the floor.
The full weight of the rack rests on the leveling jacks.
The stabilizing feet are attached to the rack if it is a single-rack installation.
The racks are coupled together in multiple-rack installations.
Only one component in a rack is extended at a time. A rack may become
unstable if more than one component is extended.
component are to be located:
a. With the front of the template and the rack facing you, align the lower
edge of the template with the bottom of the rack (or the top of the
previous rack component.)
b. After verifying that the template is level, push the template tabs into the
rack holes to hold the template in place.
Modular Smart Array 1500 cs Installation Guide
Advertisement
Chapters
Table of Contents
