Step 5: Install The Hard Drives - HP StorageWorks Modular Smart Array 1500 cs Installation Manual

Step 5: Install the hard drives

After the storage enclosures are installed and secured in the rack, install your hard
drives into the drive bays.
For a list of the hard drives that are supported for use with the MSA1500 cs and
your storage enclosure, read the MSA1500 cs Compatibility Guide, located on the
MSA1500 cs Technical Documentation page of the MSA1500 cs web site at
http://www.hp.com/go/msa1500cs
Figure 10: Installing hard drives into sample storage enclosures
Note:
information for your storage enclosure in the enclosure documentation.
For information about installing hard drives, refer to the instructions that came
with the hard drive and the enclosure. Make sure the drives are fully seated.
Go to
about your hard drives.
Modular Smart Array 1500 cs Installation Guide
Caution: Follow industry-standard practices when handling hard drives.
HP recommends installing hard drives in bay-number sequence. Locate this
Table 12: "Hard Drive
Installation Procedures - All Deployments
.
Information" on page 92 to record information
35