Table of Contents
Advertisement
Configuration Procedures - Linux Environments
Installing the HBA Driver on your Linux servers
Because this process involves updating your server configuration, HP
recommends performing this task during inactive periods.
Two methods are available for loading the HBA driver, each of which is discussed
in the following paragraphs:
The installed HBA driver automatically loads on each system boot and provides
optimized support for single- and multi-path configurations.
Using the provided RPM file
1. With the HBA(s) installed in the server, power on the server and start up your
Note:
performing a server upgrade or move), disconnect the MSA1500 cs from the SAN. If
the MSA1500 cs is unconfigured, the MSA1500 cs can be connected to the SAN.
2. From the console, log on as the root user.
3. Insert the MSA1500 cs Support Software CD in the CD-ROM drive of the
4. From the console, mount the CD-ROM drive and view the contents of the CD.
5. Locate and read the readme.txt file to review notes and information that
6. Navigate to the /LINUX directory on the CD.
66
Caution:
You must use the MSA1500 cs Support Software CD to install the
driver for the HBA on the server. Drivers for all supported HBAs are included
on the CD and are the only versions approved for use with the MSA1500 cs.
Do not obtain or use an HBA driver from the HBA manufacturer or the
MSA1000 web site.
Using the provided RPM file (recommended)
Compiling a driver from source code
Linux operating system.
If LUNs on the MSA1500 cs are already being presented to the server (when
server.
supplement this guide.
Modular Smart Array 1500 cs Installation Guide
Advertisement
Chapters
Table of Contents
