Read The Messages On The Controller Display Panel - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

Read the messages on the controller display panel

Each controller contains an integrated LCD panel. This panel displays
informational and error messages, shows the current status of the MSA, and
provides an interface for user input. To verify that your MSA is operating
properly, use the arrow buttons on the LCD panel of the controller and look for the
following messages:
Table 8: MSA1500 Startup Messages
Startup Complete
Fibre Sub-System Link Failure
Array controller Firmware ver
<version>
If the
■
■
■
■
Go to
firmware version.
HP StorageWorks 1500 Modular Smart Array Installation Guide
Message
Startup Complete
Check the cable connections to the MSA
Check the availability of your power source
Review the setup instructions in the previous sections of this guide
Refer to the HP StorageWorks MSA1500 Maintenance and Service Guide,
available on the Documentation CD and the Technical documents page of the
MSA1500 website: http://www.hp.com/go/msa1500cs.
Table 10: "MSA1500
The array controller has completed its
power on sequence and is operational.
No active fiber connection to the MSA
controller exists. This message is
expected, because, although you have
physically installed the HBA in the
server, you have not yet installed the
drivers for the HBA and the MSA.
You may safely ignore this message.
The current version of the firmware
running on the controller.
message is not displayed:
Information" on page 108 to record the controller
Installation Procedures - All Deployments
Meaning
59