Angle Adjustment - SHOWTEC Luna Par 120 Q4 User Manual

Luna Par 120 Q4
To mount the device, follow the steps below:
01) Use a clamp to attach the device to the supporting structure, as shown in Fig. 07. Make sure that the
device cannot move freely.
02) Secure the device with a secondary suspension, for example a safety cable. Make sure that the
secondary suspension can hold 10 times the weight of the device. If possible, the secondary
suspension should be attached to a supporting structure independent of the primary suspension. Put
the safety cable around the mounting bracket (01), as shown in Fig. 07.

Angle Adjustment

You can adjust the angle of the device with the 2 adjustment screws (03).
01) Turn the adjustment screws (03) counterclockwise to release them.
02) Tilt the device at the desired angle (see Fig. 08).
03) Turn the adjustment screws (03) clockwise to tighten them. Make sure that the device cannot move
freely after the adjustment screws (03) are tightened.
Product code: 43322
13
Fig. 07
Fig. 08