Table of Contents
Advertisement
Luna Par 120 Q4
Settings
In this menu you can adjust different parameters of the device.
01) Press the UP/DOWN buttons to select one of the following options:
●
Curves Select:
●
Dimmer Speed:
●
PWM Frequency:
●
DMX Fail:
●
DMX Sync:
●
Lock:
●
Factory:
02) Press the SETUP button to confirm the selection.
DMX Fail
In this submenu you can determine the behavior of the device if there is no DMX signal.
01) Press the UP/DOWN buttons to select one of the following 3 options:
●
Off:
●
Hold:
●
Manual:
●
Program:
02) Press the SETUP button to confirm the selection.
Product code: 43322
There are 4 options available: Linear, Square Law, Inverse Square Law and
S-Type
There are 2 options available: Fast and Smooth
There are 4 options available: 12K (12000 Hz), 6K (6000 Hz), 4K (4000 Hz), and
3K (3000 Hz)
See 6.6.7.1. DMX Fail
Synchronization over DMX (On/Off). The speed, with which the built-in
chases are played, can change over time. Thus, if you run shows with
multiple devices connected on one DMX link, the output may not be
synchronous. Enable this option to activate the synchronization of the
output across all devices connected on one DMX link.
See 6.6.7.2. Lock
Reset the device's settings to the default factory settings (Yes/No)
The device will black out the light output
The device will use the last properly received DMX signal
The device will use the last working manual settings selected in manual
mode. See 6.6.2. Manual Mode on page 24 for more information
The device will run the last selected color preset or built-in chase. See 6.6.4.
Program Settings on page 25 for more information
26
Advertisement
Table of Contents
