Audi A4 2015 Workshop Manual page 51

Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
– Insert brace -T40335- in subframe on both sides. If necessary,
adjust brace at knurled handle -1-.
– Secure brace with a split pin -arrow- on both sides.
♦ -T40334- can be disregarded.
Caution
Risk of damage to boots.
♦ Do not hold onto the boots of the steering rack when re‐
moving it.
– Support steering rack -2- with engine and gearbox jack - VAS
6931- (place a suitable piece of foam -1- between steering
rack and jack).
– Unscrew locating pins -T40334- on left and right.
– Lower steering rack and press forwards slightly.
All vehicles
– Remove bolt -1- using ring spanner insert, 16 mm - V.A.G
1332/14- and adapter - VAS 6948- .
– Pull starter off gearbox slightly but do not remove starter.
Vehicles with 3.0 ltr. TDI engine
– Bring steering rack back into its installation position and se‐
cure with locating pins -T40334- .
All vehicles
– Unscrew remaining bolts -6 ... 10- securing gearbox to engine.
– Position engine and gearbox jack - VAS 6931- with gearbox
support - T40173- (set up beforehand) underneath gearbox
and secure with tensioning strap -1- as shown in illustration.
– Remove tunnel cross member
– Detach gearbox from engine and lower carefully using engine
and gearbox jack - VAS 6931- (pay attention to electrical wiring
and SCR line when doing so).
2.1.2 Removing gearbox - A4/A5 with 2.0 ltr.
TDI engine (PR no. T98)
Special tools and workshop equipment required
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
⇒ page 74 .
2. Removing and installing gearbox
47