Audi A4 2015 Workshop Manual page 89

Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
Note
Place a cloth underneath to catch escaping coolant.
– Clamp off coolant hoses using hose clamps up to 25 mm -
3094- and disconnect hoses (release hose clips -1, 2-).
– Place used oil collection and extraction unit - VAS 6622A- un‐
derneath.
– Unscrew bolts -1, 2, 3- and detach bracket.
– Detach ATF cooler -2- from ATF pipe -1-.
– Seal off open lines and connections with clean plugs from en‐
gine bung set - VAS 6122- .
– Detach ATF pipe.
Installing
Installation is carried out in reverse order; note the following:
Note
Renew ATF pipe with seals after removal.
♦
Clean ATF cooler before installing.
♦
Caution
Risk of leaks at ATF cooler!
♦ Note installation position of ATF pipe.
♦ Pipe end with three seals faces ATF cooler.
– Screw in bolts by hand until they make contact and then tighten
to specified torque.
– If bolts are not accessible, tighten using Torx screwdriver bit
T30 - VAS 6959- .
– Check ATF level ⇒ page 91
Tightening torques
♦ ⇒ Fig. ""ATF cooler - tightening torque and sequence"" , page
82
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
.
85
7. ATF circuit