Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
Test conditions
•
Gearbox must not be in emergency running (backup) mode.
•
Vehicle must be absolutely horizontal (on a four-pillar lifting
platform or over an inspection pit).
•
Gearbox is in position "P".
•
Parking brake button must be pulled up to apply the electro‐
mechanical parking brake.
•
Extraction hose(s) of an exhaust gas extractor (switched on)
must be connected.
•
Air conditioner and heating switched off.
•
Vehicle diagnostic tester is connected.
•
The ATF temperature must not be higher than 35 °C at the
beginning of the test. If the temperature is higher, allow the
gearbox to cool down before proceeding.
Note
ATF level will change depending on ATF temperature.
♦
If ATF level is checked when ATF temperature is too low, this
♦
will lead to overfilling.
If ATF level is checked when ATF temperature is too high, this
♦
will lead to underfilling.
Both overfilling and underfilling will impair the function of the
♦
gearbox.
Procedure
Note
Renew plug for inspection and filler hole.
– Connect Vehicle diagnostic tester and start
♦
Select own test
♦
02 - Gearbox electronics, Guided Functions
♦
⇒
Check ATF level
– Follow instructions on screen.
Caution
Risk of damage to gearbox
♦ The engine must not be started if only a little or no ATF
remains in gearbox after repair work or after excessive
ATF leakage.
♦ In this case the gearbox must be filled with ATF before
proceeding further
– Remove noise insulation (rear) ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Noise insulation; Removing and installing
noise insulation .
92
Rep. gr.34 - Controls, housing
Diagnosis
3 Check ATF level
⇒ page 94
.
mode.