Table of Contents
Advertisement
2. INSTALLATION
2. INSTALLATION
WARNING
CAUTION
To prevent electric shock, ground each equipment securely.
Stacking in excess of the specified number of product packages is not allowed.
Install the equipment on incombustible material. Installing them directly or close to
combustibles will lead to a fire.
Install the servo amplifier and the servo motor in a load-bearing place in
accordance with the Instruction Manual.
Do not get on or put heavy load on the equipment. Otherwise, it may cause injury.
Use the equipment within the specified environment. For the environment, refer to
section 1.5.
Provide adequate protection to prevent screws and other conductive matter, oil
and other combustible matter from entering the servo amplifier and MR-D30.
Do not block the intake and exhaust areas of the servo amplifier and MR-D30.
Otherwise, it may cause a malfunction.
Do not drop or strike the servo amplifier and MR-D30. Isolate them from all impact
loads.
Do not install or operate the servo amplifier and MR-D30 which have been
damaged or have any parts missing.
When the product has been stored for an extended period of time, contact your
local sales office.
When handling the servo amplifier and MR-D30, be careful about the edged parts
such as corners of them.
The servo amplifier and MR-D30 must be installed in a metal cabinet.
When fumigants that contain halogen materials such as fluorine, chlorine,
bromine, and iodine are used for disinfecting and protecting wooden packaging
from insects, they cause malfunction when entering our products. Please take
necessary precautions to ensure that remaining materials from fumigant do not
enter our products, or treat packaging with methods other than fumigation (heat
method). Additionally, disinfect and protect wood from insects before packing
products.
POINT
When pulling out CNP1, CNP2, and CNP3 connectors of 200 V/100 V class
servo amplifiers of 600 W or lower, pull out the CN3 connector beforehand.
2 - 1
Advertisement
Table of Contents
