Diagnosis / Error Messages; Error Codes - ABB TZIDC-210 Operating Instructions Manual

60 TZIDC-210, TZIDC-220 DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G

11 Diagnosis / error messages

Error codes

Error code Possible cause
Defective memory chip
Automatic adjustment function lasts too long.
Mounting conditions not correct. Position outside
sensor range.
1 Inconsistent data, e.g., low value > than high
value, or incorrect configuration.
2 Data cannot be saved locally, as PROFIBUS saves
data in the background.
The device is not in the safe position.
Alarm message (can only be read out using the DTM).
• Temperature alarm
• Automatic adjustment has failed
• Zero point has shifted
• Device reset
• Maintenance required
• Motion counter limit value up-scaled
• Travel counter limit value up-scaled
• Limit switch 1 up-scaled
• Limit switch 2 up-scaled
• Position outside operating range
• Position outside sensor range
• Invalid set point
• Local operating mode requested
• Local operating mode active
• Simulation active
• Controller deactivated
No PROFIBUS communication.
Position sensor defective
Defective memory chip
Impact
Device does not boot up.
Autoadjust function is aborted.
.
Autoadjust function is aborted.
1 Automatic adjustment is aborted.
2 Saving is not possible.
See DTM online help
No PROFIBUS communication.
Device moves to safety position.
Device does not boot up.
Troubleshooting the Instrument
Return the device for repair.
Increase the supply pressure or use
boosters.
Check mounting conditions.
1 Correct values or load factory
settings.
2 Try again at a later point.
Move the device to the safe position.
See DTM online help
Check bus address and status bit (128).
Return the device for repair.
Return the device for repair.