TZIDC-210, TZIDC-220 DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G
Setting the bus address
1. Switching to the configuration level:
•
Press and hold down and simultaneously,
•
additionally quickly press and release ENTER,
•
Wait for the countdown to go from 3 to 0,
•
Release and .
The following is now shown in the display:
conf
2. Switch to parameter group 1.5:
Press and hold downMODE and ENTER simultaneously,
•
•
In addition, press and .
The following is now shown in the display:
conf
•
Release MODE.
The following is now shown in the display:
conf
3. Setting the bus address:
•
Press or to set the correct value,
Press and hold down ENTER until the countdown goes
•
from 3 to 0,
Release ENTER.
•
The new bus address is saved.
4. Switching to parameter 1.6 (return to operating level) and
saving the new settings:
•
Press and hold downMode,
•
In addition, briefly press 2×,
the following is now shown in the display:
•
ReleaseMODE,
•
Quickly press and release to select NV_SAVE,
•
PressENTER and hold down until the countdown goes
from 3 to 0.
The new parameter setting is saved and the positioner
automatically returns to the operating level. It continues in the
operating mode that was active prior to the configuration level
being called up.
°
C
%
Request information
When the device is in BUS operation, the information shown
below can be called up.
Press the following control buttons to access this information:
Control buttons
Action
Cyclic communication:
The set point in % and the set point status
is displayed.
Acyclic communication:
Displays the communication status.
Displays the bus address and operating mode
Displays the software revision
ENTER
Operating modes
Selection from the operating level:
1. Press and hold MODE.
2. Also press and release rapidly as often as required. The
selected operating mode is displayed.
3. Release MODE.
The position is displayed in % or as a rotation angle.
Operating mode
Mode indicator
1.1
Positioning with fixed set
point.
Adjust set point using
or .
1.2
Manual adjustment * in
the operating range.
Adjust with or **
1.3
Manual adjustment *
within the sensor range.
Adjust with or **
*
Positioning not active.
** For high-speed mode: Press and simultaneously.
51
Position indicator