Mounting On Linear Actuators - ABB TZIDC-210 Operating Instructions Manual

TZIDC-210, TZIDC-220 DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G

Mounting on linear actuators

For mounting on a linear actuator in accordance with DIN /
IEC 60534 (lateral mounting as per NAMUR), the following
attachment kit is available.
1 Screw
2 Washer
3 Mounting bracket
4 Lever with follower pin (for travel
10 to 35 mm (0.39 to 1.38 in) or
20 to 100 mm (0.79 to 3.94 in)
5 Washers
6 Screws
Figure 8: Components of attachment kit
7 U-bolt
8 Washers
9 Nuts
j Screws
k Spring washers
l Clamp plates
m Follower guide
Figure 9: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
screws 4 and spring washers
Figure 10: Assemble lever (if not pre-assembled)
1. Insert spring 8 on bolt with follower pin
2. Slip the plastic washer 7
spring with it.
3. Insert the bolt with compressed spring into the oblong hole
in the lever 6 and fasten it in the desired position using the
plain washer 5 and nut
lever indicates the link point for the stroke range.
4. Place the washer on the screw
2
lever and lock with the nut
1 and clamp plates 2 with
3 to the actuator stem.
9 .
onto the bolt and compress the
4 at the lever. The scale on the
. Insert the screw in the
1
.
3
39