Transport And Storage; Inspection; Transporting The Device; Storing The Device - ABB TZIDC-210 Operating Instructions Manual

TZIDC-210, TZIDC-220 DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G

5 Transport and storage

Inspection

Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.

Transporting the device

Observe the following instructions:
• Do not expose the device to humidity during transport.
Pack the device accordingly.
• Pack the device so that it is protected against vibrations
during transport, for example, by using air-cushioned
packing.

Storing the device

Bear the following points in mind when storing devices:
• Store the device in its original packaging in a dry and
dust-free location. The device is also protected by a
desiccant in the packaging.
• The storage temperature should be between −40 to 85 °C
(−40 to 185 °F).
• Avoid storing the device in permanent direct sunlight.
• In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in
the order confirmation of the supplier apply.

Ambient conditions

The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!

Returning devices

For the return of devices, follow the instructions in Repair on
page 63.

6 Installation

Safety instructions

CAUTION
Risk of injury
Risk of injury from pressurized positioner / actuator.
• Before starting work on the positioner / actuator, switch
off the air supply and vent the positioner / actuator.
CAUTION
Risk of injury due to incorrect parameter values!
Incorrect parameter values can cause the valve to move
unexpectedly. This can lead to process failures and result in
injuries.
• Before recommissioning a positioner that was previously
in use at another location, always reset the device to its
factory settings.
• Never start automatic adjustment before restoring the
factory settings!
Note
Before assembly, check whether the positioner meets the
control and safety requirements for the installation location
(actuator or final control element).
Refer to the Specification in the data sheet.
Only qualified specialists who have been trained for these tasks
are authorized to mount and adjust the unit, and to make the
electrical connection.
When carrying out any work on the device, always observe the
local accident prevention regulations and the regulations
concerning the construction of technical installations.
37