Mounting On Rotary Actuator - ABB TZIDC-210 Operating Instructions Manual

42 TZIDC-210, TZIDC-220 DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G
... 6 Installation
... Mechanical mounting

Mounting on rotary actuator

For mounting on part-turn actuators in accordance with
VDI / VDE 3845, the following attachment kit is available:
Figure 16: Components of attachment kit
Adapter 1 with spring 5
•
four M6 screws each 4, spring washers 3 and
•
washers 2 for fastening the attachment bracket 6 on the
positioner
four M5 screws each 7, spring washers 8 and
•
washers 9 for fastening the attachment bracket to the
actuator
Required tools:
• Wrench, size 8 / 10
• Allen key, size 3
Figure 17: Mounting the adapter on the positioner
1. Determine the mounting position (parallel to actuator or at
90° angle)
2. Calculate the rotational direction of the actuator (right or
left).
3. Move the part-turn actuator into the home position.
4. Pre-adjust feedback shaft.
In order for the positioner to work within the working range
(see General on page 38), the installation position as well as
the basic position and direction of rotation of the actuator
when determining the adapter position on the axis 1
should be considered. For this purpose, the axis can be
adjusted by hand to set the adapter 3 accordingly in the
correct position.
5. Place the adapter in the suited position on the axle and
secure with threaded spuds 2. One of the threaded pins
must be locked in place on the flat side of the feedback shaft.