CR 30-X
Stopping CR 30-X
Before Switching Off
Check that the CR 30-X is not scanning an image plate. If the CR 30-X is
scanning an image plate, the status indicator is flashing green.
Switching Off
It is recommended to switch off the CR 30-X at the end of the day.
To switch off, press the main switch to the Off ("0") position.
34
Getting Started with the CR 30-X
Note: Only switch off the CR 30-X if you do not intend to digitize emergency
image plates overnight. Switching on the CR 30-X takes approximately
60 seconds. During this time emergency digitizing is not possible!
Main switch
2386B EN 20060926