Connectivity; Installation - AGFA CR 30-X User Manual

CR 30-X

Connectivity

The CR 30-X is connected to the workstation via a FireWire connection and
uses a dedicated protocol to communicate with the workstation.

Installation

CR 30-X installation and configuration is performed by Agfa.
The CR 30-X is equipped with 2 handles at the bottom left and right sides to
move the device easily to another location. It is recommended to have at least
two persons lift the CR 30-X.
16
Introduction
Caution: When installing the CR 30-X, care must be taken to ensure that
there is either a mains plug or an all-cable disconnecting device in the
internal installation fitted near the CR 30-X and that it is easily
accessible.
Caution: If the CR 30-X is installed inside of an X-ray room it must be
protected from stray radiation by proper shielding.
WARNING: The CR 30-X is a tabletop digitizer. The structure and
stability of the table used, need to be suitable in relation with the
size and weight of the system. The table should not be subject to
excessive shock and vibrations from other sources, as this may
disturb the operation of the CR 30-X.
2386B EN 20060926