CR 30-X S
YSTEM
Starting the CR 30-X System
To start the CR 30-X System:
1
Turn on the UPS (optional accessory) to supply electricity to the control PC and
the digitizer CR 30-X.
Check whether the UPS is connected to a power outlet.
Press and hold the On button approximately one second until you hear the UPS beep.
2
Start NX.
The NX application is available on the control PC.
For detailed information about starting up NX, refer to the NX User Manual,
document 4420.
3
Switch on the CR 30-X by pressing the main switch.
For detailed information, refer to the CR 30-X User Manual, document 2386.
12
Getting Started with the CR 30-X System
Note: Step 1 is only applicable if your CR 30-X System is extended with an
uninterruptible power supply (UPS).
2385A EN 20060630