Progress Solar/Wind SLT 700 Series Operator's Manual page 7

Light tower
Table of Contents

Advertisement

Standard Features & Specifications
Progress Solar™ & Solar/Wind™ Light Tower (Towable)
SOLAR, WIND & AC POWER GENERATORS & STORAGE
 Power Generation – Solar & Wind Power w/ Critical Elements to Maximize
Power
o Two monocrystalline solar arrays housed on two solar wings. Each solar
array is made up of one or multiple solar modules x 2 solar arrays
o The 2 adjustable solar wings use actuators to raise, lower and stabilize the 2
solar wings mounted on each side of the unit at angles required to function
on each side. When deployed, these angles allow operators to optimize
solar wings to any geographic area latitude from either side of the unit; and
for travel, position both solar wings out of harm's way.
o The high wind stabilization package includes 4 Progress Solar Tele-Struts™
to secure the solar wings and the 5 outriggers/jacks stabilize the unit during
high wind.
o Each solar wing housed on each side of unit facing out and hinged at the
top. This minimizes any potential damage in the transit (travel position)
while maximizing solar exposure (optimal latitude) in the deployed position
from either side of the unit. The hinge height on the solar wings specifically
prevents shade from any adjacent vehicles or equipment. If your unit has
additional foldout hinges on the sides (SLT1000, 1200, 2800) then you
when stored you must unfold the wings to allow all panels to be exposed to
sunlight to get effective charging. Positioning solar arrays at optimal
latitude and eliminating shade over the unit are critical for
performance and prevent permanent damage to batteries.
o The Optional Wind Turbine adds additional power up to 200W at speeds
greater than 7mph. This helps power the unit 24hrs/day especially when
sun is down and in inclement weather.
 Power Storage & Backup AC Charger
o 24 Volt DC deep-cycle, battery bank comprised of AGM (sealed, no
maintenance) batteries (most units); 800aH (>/=780-830aH) (optional
1200aH) capacity of battery bank.
o For Backup AC Charging Power – U.S. 110-120VAC/20amp (ex U.S. 220-
240VAC/20amp), 50/60Hz dual AC rapid-charger capable of charging up to
40aH to 24VDC battery bank using generator or any other standard 20amp
commercial electrical source. Lights can be operated while batteries are
being charged
o Battery State-Of-Charge Meter – Incremental display of battery charge
o 50 ft, 20amp electrical cord to use with AC battery charger
SLT and SLT(W) Series
7 |
P a g e

Advertisement

Chapters

Table of Contents
loading

Related Products for Progress Solar/Wind SLT 700 Series

Table of Contents