Auxiliary Connection For Temperature Monitoring; Programmable Relay - Progress Solar/Wind SLT 700 Series Operator's Manual

1. Connect the ferrule pin of the second red cable with fuse to the shunt by pushing the pin into to the +B2 terminal.
2. Connect the M10 lug of the second red cable with fuse to the positive terminal of the midpoint.
For more information on midpoint monitoring and for additional diagrams on midpoint battery bank wiring see the
monitoring [46] chapter.

3.6.3. Auxiliary connection for temperature monitoring

For use to monitor the temperature of a battery via the (not included)
temperature sensor needs to be purchased separately. Be aware that this is a different temperature sensor than the temperature
sensors that are included with Victron inverter/chargers and some battery chargers.
Connection procedure:
• Connect the ferrule pin of the black temperature sensor wire by pushing the ferule pin into the +B2 terminal.
• Connect the ferrule pin of the red wire cable by pushing the ferule pin into to the +B1 terminal.
• Connect the M10 cable lug of the temperature sensor to the positive battery terminal.
Note that if the temperature sensor is used, the two red cables with fuse that came with the battery monitor
are not needed. The temperature sensor will replace these cables.

3.7. Programmable relay

The battery monitor is equipped with a programable relay. This relay can be used as an alarm relay, to start a generator or
for other applications. For more information on the various relay modes and how to configure the relay, see chapter
settings [31].
Page 9
Manual - BMV-712 Smart
Battery monitor with auxiliary midpoint monitoring.
Temperature sensor for BMV-712 Smart and BMV-702
Temperature sensor for the battery monitor
Battery monitor with auxiliary temperature sensing.
Midpoint voltage
Loads
&
Chargers
Loads
&
Chargers
. This
Relay
Installation