Progress Solar/Wind SLT 700 Series Operator's Manual page 19

3) To review programs
Press TIMER to alternate and display each setting on the LCD screen.
4) To operate, Press MANUAL to select ON, AUTO or OFF setting mode. Note a will
appear under ON, AUTO or OFF to designate current operating mode and will cycle if
you press MANUAL.
a) The manual ON and OFF temporarily override the AUTO (automatic setting that
you set in #2 above). It is recommended to set your TIMER, turn it to AUTO
(automatic) and it will operate as requested. For days that you want to override the
AUTO setting simply press MANUAL turning the light On (LED will also turn red)
and then push MANUAL one additional time to AUTO again. The light will then turn
on instantly as requested and will still turn Off at its established automatic Off time.
5) To Reset, press X on controller to clear previous settings
Note: The Light Timer uses a Lithium CR2032 battery and is within a compartment on the
back of the timer.
Battery State-of-Charge Meter Operation
The Battery State-of-Charge Meter(s) are included in
some SLT & SLTW units. The meter is located
inside the front control box. This component provides
the SLT/SLTW operator an easy-to-understand
visual display indicating the current battery state-of-
charge at a glance. Newer units may have the
Victron state of charge meter instead of this meter.
The operator sees the current charge levels in increments to maximize battery life, it is
best to limit your discharge rate to no lower than 30% of the capacity of the battery bank
and to fully charge the batteries on a routine basis. This charge can be achieved by either
or a combination of solar gain or with an on-board backup electric (AC) battery charger.
19 | P a g e