Progress Solar/Wind SLT 700 Series Operator's Manual page 32

Gas/LPG Hybrid Generator (SHYB Models)
Q) Why don't I have any power to my generator?
• A) Check to make sure the main Disconnect Switch located in the front of the unit is
in the ON position.
Check to make sure the light for the generator battery is ON and the led indicator is
◦
lite up.
◦ Check and make sure the toggle switch for the generator itself it in the RUN position.
• Once you have checked the above steps locate the Dynagen controller in the control
panel. It should be on and will say "NOT IN AUTO, WAITING TO START"
Q) How do I manually start the generator?
• A) Make sure the generator has the proper fuel type you will be using i.e., LPG or
Gasoline.
• Make sure the Oil is full.
• Then on the Dynagen Auto start controller, push the auto button once then the run button,
you will see a count down and then the generator will begin trying to start.
Q) If I manually start my generator, will it turn off with the auto start?
• A) No, if you manually start the generator you need to manually turn off the
generator.
Q) How to I put the generator in auto start?
• A) To do this all you need to do it make sure the Dynagen controller is on. (IF it isn't
push, the off button and wait for it to load and turn on)
• After it's on, Simply push the Auto button on the controller and it should now read across
the screen "IN AUTO WAITING TO START".
• Now it's in the auto mode.
Q) My generator is not cranking.
• A) There could be several reasons why the generator did not crank.
▪ Check that the propane tanks are open and propane tanks have propane.
▪ Check to make sure generator toggle switch is in the ON position.
Check the breaker on the generator is ON.
▪
Check your oil level, generator has a low oil shut-off which will not allow
▪
generator to turn ON if oil level is low.
w. ProgressSolarSolutions.com Sales@ProgressSolarSolutions.com p. 919.363.3738 1108 N New Hope Rd, Raleigh, NC 27610