Accessories - Progress Solar/Wind SLT 700 Series Operator's Manual

2.5. Accessories

These optional parts might be needed depending on your setup:
• Temperature sensor for BMV
• GX Device, such as a Cerbo GX
• VE.Direct cable - to connect the battery monitor to a GX device.
• VE.Direct to USB interface - to connect to the battery monitor via USB to a GX device or to the VictronConnect app.
• Wall mount enclosure for BMV or MPPT Control
• Wall mount enclosure for BMV and Color Control GX
Control GX in the same enclosure.
• RJ12 UTP cable - use in case the supplied 10m (32ft) RJ12 cable (the cable between the shunt and the head unit) is too long
or too short. These cables are available in a variety of lengths of 30cm up to 30 meters (1ft up to 98ft).
Page 3
Manual - BMV-712 Smart
- to measure the battery temperature.
- for system and/or remote monitoring.
- use in case panel mounting of the battery monitor head unit is not possible.
- use to wall mount the battery monitor head unit together with a Color
Introduction