Progress Solar/Wind SLT 700 Series Operator's Manual page 15

Operating Instructions
Transport & Towing
Close solar wings completely into down position tightly against the sides of the unit

before transit. Secure all latches and connectors prior to transit.
Lower light tower down to its lowest position. It is optional but encouraged to turn

flood lights so they are pointing down and turn light bar to parallel with hitch direction
to reduce drag during towing.
Retract all jack stands and outriggers accept the tongue jack and make sure they are

properly stowed and outrigger pins locked for transit.
Position vehicle ball under trailer connector. Crank down (counter-clockwise) tongue

jack to lower trailer.
Place coupler over ball (or lunette ring if applicable) and secure the unit to towing vehicle.

Stow tongue jack to raised/locked position for transit. Lower jack by turning (counter

clock-wise) the side mounted crank. Pull lock pin out and rotate jack to the horizontal
position, parallel to trailer tongue and release lock pin. Make sure spring lock pin is
completely inserted in correct hole.
Attach safety chains and allow adequate slack (chains should not drag ground).

Attach brake and light quick connects to towing vehicle.

Check for loose debris hanging from the trailer.

Check tire air pressure and tire condition. Tighten any lug nuts that may be loose.

Make sure all lock pins (especially outriggers and jacks) are correctly inserted.

Make sure license plate is attached and current (where required).

WARNING: MAKE SURE TRAILER HITCH AND BALL ARE CORRECT
SIZES. SECURE THE TRAILER CORRECTLY TO TOWING VEHICLE.
WARNING: FOLLOW ALL LOCAL AND STATE SPEED LIMITS AND
D.O.T LAWS WHEN TOWING A TRAILER.
CAREFUL DURING WHEN MAKING SHARP OR SUDDEN TURNS
Before getting started inspect the entire unit for loose debris or damaged parts.
Get acquainted with the safety and instructional decals located on the unit.
SLOW DOWN AND BE ESPECIALLY
15 | P a g e