Test Selected Cannot Gain Access To Hoses; Power Fail Test Failed; Selected Operation Cannot Gain Access To Resources Currently Performing Communications; User Id/Vehicle Id Cannot Be Verified - Syn-Tech Systems FuelMaster Plus Operation Manual

SECTION VIII -ERROR MESSAGES & TROUBLESHOOTING

TEST SELECTED CANNOT GAIN ACCESS TO HOSES

Wait a few seconds and try selected test again.

POWER FAIL TEST FAILED

Manually power-fail the FMU.
SELECTED OPERATION CANNOT GAIN ACCESS TO RESOURCES
CURRENTLY PERFORMING COMMUNICATIONS
Wait until the 'ON-LINE' message on the LCD display disappears and retry
operation.

USER ID/VEHICLE ID CANNOT BE VERIFIED

The FMU is currently receiving a new authorization list and is unable to verify
the entry. Wait a few seconds and retry transaction.
Transactions memory is full. FMU must be downloaded by Central Controller
before allowing any further transactions.

FMU HARDWARE FAILURE!!

• Call Syn-Tech's Customer Satisfaction Center immediately.
(850) 878-2558
** POWER RESET TEST *
* UNABLE TO RESTART - PLEASE POWER FAIL UNIT
** SELECTED OPERATION IS NOT **
** PERMITTED WHILE SYSTEM IS ON-LINE ! **
** RECEIVING NEW AUTHORIZATION LISTS ! **
** UNABLE TO VERIFY -PLEASE TRY AGAIN ! **
** FMU TRANSACTION MEMORY FULL ! **
** PLEASE ALERT SUPERVISOR! **
** ERROR -ERROR -ERROR -ERROR **
* RAM BATTERY DEAD OR RAM MALFUNCTIONED! *
62