While Doing Self-Test During Power-Up, Fmu Misread Site Configuration Stored In Eeprom; Initialize Using Old Or New? Yes/New, No/Old - Syn-Tech Systems FuelMaster Plus Operation Manual

SECTION VIII -ERROR MESSAGES & TROUBLESHOOTING
When using "Pump handle YES" in the configuration, the user must select the
hose number before turning the handle on. In some cases, selection of
"Pump Handle NO" may be needed to resolve this situation.
VALID KEY TIMEOUT was reached or CLEAR/NO was pressed on the
keypad and confirmed to cancel transaction.
WHILE DOING SELF-TEST DURING POWER-UP, FMU MISREAD SITE
CONFIGURATION STORED IN EEPROM
Enter the code of 3A3 to have FMU try again. The prompt responds with the
following:

INITIALIZE USING OLD OR NEW? YES/NEW, NO/OLD

Press NO to instruct FMU to look for and use old configuration (site
configuration stored in EEPROM).
Press YES to have FMU use default factory configuration. WARNING! Any
previous configuration data is reset. See NOTE below.
Always select NO to use old configuration. If FMU returns to Config error, contact
STS.
** ERROR: PUMP HANDLE NOT TURNED ON **
** TRANSACTION HAS BEEN CANCELLED **
** TIME LIMIT EXCEEDED OR **
** TRANSACTION WAS CANCELLED ! **
CONFIGURATION ERROR . . . SYSTEM SHUTDOWN !
ENTER 3 - DIGIT AUTH. CODE TO EDIT CONFIG.
RESET CONFIGURATION DATA?
YES = INITIALIZE, NO = USE OLD
NOTE:
** TESTING NOT ALLOWED WHILE HOSES ARE **
** IN USE! PLEASE TRY AGAIN LATER ! **
61