Syn-Tech Systems FuelMaster Plus Operation Manual page 31

SECTION IV- TWO KEY OPERATIONS
which is greater than the MILES/HOURS range encoded on the key. One of the
following may have occurred:
the miles/hours range on the key was too low to begin with,
tenths of miles may have been entered when the entry should consist
of whole miles only,
the last time the key was used the miles/hours did not get written
back to the key,
the entry was incorrect and the ENTER/YES key was pressed,
the entry is correct but the vehicle's last fueling was off-site causing
the mile/hour range to be exceeded.
Both of these error messages require re-entry of miles or hours value. An FMU
with default configuration will accept the user's second mile/hour entry,
regardless of accuracy.
This message indicates that the miles/hours entry was accepted and the
FMU wishes to write the entry back to the key. Insert the Vehicle Key and
hold it in. The entry is written back to the key and the next prompt
appears.
If the 'Bad Odom Termination' option is enabled on the FMU, the following
display appears upon entry of two consecutive odometer entries which are
out of range of the odometer written to the key.
If the key inserted is not the Vehicle Key (as instructed by the prompt to
"REINSERT YOUR VEHICLE KEY"), a prompt with the following error
message appears:
** REINSERT YOUR VEHICLE KEY **
** TO CONTINUE **
** TRANSACTION CANCELLED BECAUSE OF **
** OUT-OF RANGE ODOMETER ENTRIES **
** ERROR: KEY INSERTED IS NOT **
** A VEHICLE KEY **
31