Syn-Tech Systems FuelMaster Plus Operation Manual page 20

SECTION II- USER KEY OPERATIONS
already in use. If an in-use hose is selected, a message will appear
telling you to select a different hose.
Once a hose has been selected, one of two messages appears on
the FMU display. These messages depend upon the type of
dispenser installed and how it was wired during installation of the
FuelMaster® hardware.
Electronic dispenser
*** DISPENSER ENABLED ***
*** DISPENSE PRODUCT ***
This authorization prompt appears if the FMU configuration is set to not
detect the pump handle. It does not matter when the pump handle is
turned on. When this message appears, the FMU is ready to track
fueling.
This authorization prompt is display if the FMU configuration is set to Pump
Handle Detect. It indicates that the FMU is ready to wait for the pump handle to
be turned on.
The following prompt indicates the dispenser hose status.
When the FMU detects that the pump handle is turned on, it responds with
the above message and is ready to track fueling.
If the above message appears, the pump handle selected was already in the
'ON' position at the time this handle was selected. To begin fueling with this
pump handle, first reset the pump handle to the 'OFF' position and wait for the
prompt to turn it on to begin fueling.
**TURN ON PUMP HANDLE TO DISPENSE
<< TURN ON PUMP HANDLE TO DISPENSE >>
<< THE SELECTED PRODUCT >>
>>> DISPENSER HAS BEEN ACTIVATED <<<
>>> RETURN HOSE AFTER USER <<<
** PUMP HANDLE NOT TURNED OFF. **
** PLEASE TURN PUMP HANDLE OFF! **
Mechanical dispenser
THE SELECTED PRODUCT**
20