Syn-Tech Systems FuelMaster Plus Operation Manual page 15

SECTION I - VEHICLE KEY OPERATIONS
After all of the required entries have been made, the following hose
selection display appears:
The choices presented in this prompt are limited to the hoses that have
the same product code(s) as those authorized for the Vehicle Key. Select
the hose and press ENTER/YES.
An asterisk '*' next to a hose number means that this hose is already in
use. A message to this effect will be displayed if you attempt to select this
hose.
Once a hose is selected, one of two messages is displayed on the FMU.
These messages depend upon the type of dispenser in use and how it
was wired during installation of the FuelMaster® hardware:
This authorization prompt appears if the FMU configuration is set to not detect
the pump handle. It does not matter when the pump handle is turned on or not.
When this message appears, the FMU is ready to track fueling.
This authorization prompt appears if the FMU configuration is set to Pump
Handle Detect. It indicates that the FMU is ready to watch for the pump handle to
be turned on. The prompt then indicates the dispenser hose status.
When the FMU detects that the pump handle has been turned on, it responds
REMOVE KEY, SELECT HOSE, PRESS <ENTER>
1, 2, 3, 4, 5, 6, 7, 8 --->
*** DISPENSER ENABLED ***
*** DISPENSE PRODUCT ***
<<< TURN ON PUMP HANDLE TO DISPENSE >>>
<<< THE SELECTED PRODUCT >>>
>>> DISPENSER HAS BEEN ACTIVATED <<<
>>> RETURN HOSE AFTER USE <<<
NOTE:
15