Magcodepowerclip Assembly Instructions - LEAB Champ User Manual

13 Appendix

13.3 MagCodePowerClip assembly instructions

To install the device, proceed as follows:
1. Cut off the old connector.
NOTE! Note the polarity of the wires.
2. Screw on the MagCode PowerClip .
3. Select the appropriate strain relief for the cable thickness.
4. If necessary, shorten the cable grommet by passing the cables through the
grommet and the strain relief and attaching the wire end ferrules.
5. Screw the cables into the terminals.
NOTE! Note the polarity of the wires.
6. Screw the housing together.
ð The device is assembled.
18 LEAB Automotive GmbH
5. Screw the MagCode PowerPort on the back with a nut
(M28).
6. Connect the cables with each other by soldering,
crimping or with connection terminals.
7. Put the fuse back in place.
ð The MagCode PowerPort is installed.
Thorshammer 6
LEAB Automotive GmbH
24866 Busdorf