Base Unit-2 (Electrical Relation); Control Pcb - Canon imageFORMULA DR-G2140 Service Manual

VII. BASE UNIT-2 (ELECTRICAL RELATION)

1. Control PCB

1) Remove the control PCB cover.
(Page 3-3)
2) Remove all cables connected to the con-

trol PCB and remove 3 locked cable
1

bands . Open the cable holder
2
remove the cable.
Note: There are 3 connectors with lock. Re-
lease the lock
connector.
Figure 3-701
COPYRIGHT © CANON ELECTRONICS INC. 2018

and
3
and remove the
CANON DR-G2140/G2110/G2090 FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
3) Remove 9 screws
round tip) and remove the control PCB
Note: Remove the cable holder, if necessary.
It is not a component of the control PCB.
Figure 3-702
Note: Don't remove a micro SD card from the
control PCB..

(M3-bind head,
1

.
2
3-39