Top Cover - Canon imageFORMULA DR-G2140 Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

5. Top Cover

1) Remove the control PCB cover.
(Page 3-3)
2) Remove the right and left covers.
(Page 3-3), (Page 3-5)
3) Remove the screw
round tip). Then hang on your fingers un-
der the cover at front/center
to front/upper side to remove a fitting part
inside. After that, while unhooking 2 pairs
of the right and left fitting parts
move the top cover
Note: Don't deform the static eliminator
brush when you hang on your fingers
under the cover.
Figure 3-210
Figure 3-211
3-6

1 (M3-TP head,

2
, and move
 
3 4 , re-

5 .
COPYRIGHT © CANON ELECTRONICS INC. 2018
 Notes on assembling
After assembling, push the cover to check
the fitting part on front side is without any
floating.
Figure 3-212
CANON DR-G2140/G2110/G2090 FIRST EDITION