How To Start And Finish - Canon imageFORMULA DR-G2140 Service Manual

CHAPTER 5 TROUBLESHOOTING

3. How to Start and Finish

 How to start
1) Start the computer for servicing.
2) If an icon of CaptureOnTouch is displayed
on the task bar, click the icon to terminate.
Note: Refer to the "User Manual" for the de-
tails of how to terminate CaptureOn-
Touch.
3) Connect the USB cable and then turn on
the machine.
4) Start up the installed file "DRUnification-
Tool.exe".
5) The password screen is displayed, so after
inputting the 6 characters "market," select
[OK].
Figure 5-205
6) The initial screen is displayed.
Figure 5-206
7) If you execute the service mode, select
[Select Scanner] and if you register the
firmware, select [Firm Registration].
5-10
COPYRIGHT © CANON ELECTRONICS INC. 2018
8) When [Select Scanner] is selected, the
scanner selection screen is displayed. Se-
lect the connected scanner.
Figure 5-207
9) The "Information" screen is displayed.
Figure 5-208
Note: Do not start up any other application
software such as CaptureOnTouch or
turn off the machine while the service
tool is running. If the tool becomes un-
responsive, you should restart the com-
puter.
 How to finish
To finish the service tool, select [:Close]
on each operation screen or select [End
Application] from [File] on the toolbar.
However, if "Firmware version update" is
performed, reset the power properly.
CANON DR-G2140/G2110/G2090 FIRST EDITION