Serial Number; Sleep Mode - Canon imageFORMULA DR-G2140 Service Manual

CHAPTER 5 TROUBLESHOOTING

5. Serial Number

This is used to check the serial number.
Figure 5-216
Serial number data is saved on the con-
trol PCB. When the control PCB is replaced,
values are displayed validly by selecting the
[Edit] button on the information screen.
Figure 5-217
Enter the serial number shown on the rat-
ing label on the main body.
Figure 5-218
After entry, select the [Apply] button on
the information screen and save the values.
If the [Cancel] button is selected on the
information screen, the changed values are
not saved.
Figure 5-219
5-14
COPYRIGHT © CANON ELECTRONICS INC. 2018

6. Sleep Mode

This is used to check and change the time
before entering sleep mode. This is set to [Af-
ter 10 minutes] by factory default.
Also, it can be checked by the user mode
using the operation panel. If you change this
setting, notify the user that you are changing
it.
Figure 5-220
To change the sleep mode setting, select
the [Edit] button in the information screen to
enable selection and setting change.
Figure 5-221
After selecting, be sure to select the [Ap-
ply] button on the information screen and
save the setting.
If the [Cancel] button is selected on the
information screen, the changed settings are
not saved.
These button operations are the same as
"Serial Number" and others.
CANON DR-G2140/G2110/G2090 FIRST EDITION