Table of Contents
Advertisement
6.1
Operation
•
Prior to firs t operation, cl ean the appli anc e and its equi pment ac cor ding to i nstr ucti ons in sect ion 6 'Cleaning'. Make sur e no water enters el ectric i nstallation and connec tion box. N astępni e dokł adni e osus z yć urz ądz enie i el ementy wypos aż eni a.
•
Setzen Sie di e Boden-Abdec kung in das Bec ken ei n. T he c over acts as a spac er between the heating element and l eft- over food tray.
•
Carefull y i nser t the c onnection box with the heati ng element at the bac k edge of the applianc e. A pin in bottom par t of the c onnecti on box must enter a hol e i n the mai n applianc e. This way the connec tion box is properly mounted.
Preparation of the Appliance
1. Before starting-up, clean the appliance inside and outside, as well as
accessories, observing indications in section 6 'Cleaning'.
2. Thoroughly dry all cleaned surfaces and elements.
3. Before the first start-up, check the correctness of installation, stability, and
levelling of the appliance, as well as execution of all connections.
Appliance Start-up
1. Switch the appliance on with ON/OFF key (1, Fig. 7) on the control panel.
After connecting the appliance to the power supply it is in standby mode.
The control panel is equipped with the rotary control knob (4, Fig. 7). Rotate the
rotary control knob to set the required parameters and press it to confirm the set
values.
To compensate the heat loss during door opening while putting food products
inside, it is recommend to preheat the appliance (section 'Manual baking/setting
of automatic preheating').
EN
28 / 70
Operating Instruction
117262
Advertisement
Table of Contents
