Mars Comfort-Aire Century VCD-SA Series Service Manual page 199

Service Manual - VCDxxSA
11. PCB board 11
Procedure
1) Disconnect the connector for
compressor and release the ground
wire(1 screw). (see CJ_ODU_
PCB_011-1 ).
2) Remove the electronic control
box subassembly. (see CJ_ODU_
PCB_011-2 ).
Note:Electric control box cover cannot
be removed, so the voltage between P
and N cannot be measured.
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
Outdoor Unit Disassembly 30

CJ_ODU_PCB_011-1
CJ_ODU_PCB_011-2
