Table of Contents
Advertisement
R&S FSL
Display of Hardware Settings
Reference level
Ref
Reference level offset
Offset
RF attenuation that has been set.
Att
Resolution bandwidth that has been set.
RBW
If the bandwidth does not correspond to the value for automatic coupling, a
green asterisk "*" will appear in front of the field.
Video bandwidth that has been set.
VBW
If the bandwidth does not correspond to the value for automatic coupling, a
green asterisk "*" will be displayed in front of the field.
Sweep time that has been set.
SWT
If the sweep time does not correspond to the value for automatic coupling,
an asterisk "*" will displayed in front of the field. The color of the asterisk
will turn to red if the sweep time is set below the value for automatic
coupling. In this case, the sweep time must be increased.
Results of the limit check.
LIMIT
CHECK
The x and y axis positions of the last marker or delta marker that was set
Marker /
as well as its index. The value in the square brackets after the index
Delta
indicates both the trace to which the marker is assigned and the active
measurement function.
The measurement functions of the markers are indicated with the following
abbreviations:
• FXD
• PHN
• CNT
• TRK
• NOI
• MOD
• TOI
1300.2519.62
Reference fixed marker active
Phase noise measurement active
Frequency counter active
Signal track active
Noise measurement active
Measurement of the AM modulation depth active
TOI measurement active
Information in the Diagram Area
4.3
E-10
Advertisement
Table of Contents
