Result Display Settings - Rohde & Schwarz EVSG1000 User Manual

®
R&S EVSG1000
Return values:
<State>
Manual operation:
SETUP:BB_IN_FACTOR? <Value>
SETUP:BB_IN_FACTOR <Value>
Gets or sets a compensation factor for the baseband (LF In) input power.
Parameters:
<Value>
Return values:
<State>
Manual operation:
SETUP:BB_IN_RANGE?
SETUP:BB_IN_RANGE <Sensitvity>
Gets or sets sensitivity range for the baseband (LF In) input.
Parameters:
<Sensitvity>
Return values:
<State>
Manual operation:

10.1.5 Result Display Settings

The following commands are required to configure the result displays for measure-
ments.
SETUP:UNIT:BARGRAPH?
SETUP:UNIT:BARGRAPH
SETUP:UNIT:DDM?
SETUP:UNIT:DDM
SETUP:UNIT:ILSPHASE?
SETUP:UNIT:ILSPHASE
SETUP:UNIT:POLARITYDDM?
SETUP:UNIT:POLARITYDDM
User Manual 1178.6227.02 ─ 06
READY.
The command was executed successfully.
See "Coupling" on page 84
Factor to be applied to the measured LF power.
READY.
The command was executed successfully.
See "LF In Factor"
100_MV
Sets 100 mV.
5V
Sets 5 V.
1V
Sets 1 V.
READY.
The command was executed successfully.
See "Range" on page 84
............................................................................................ 251
.............................................................................................. 251
....................................................................................................... 251
......................................................................................................... 251
...............................................................................................251
.................................................................................................251
....................................................................................... 252
......................................................................................... 252
Common Instrument and Measurement Setup
on page 85
Remote Commands
250