Result Display Settings; Setup:unit:bargraph - Rohde & Schwarz EVSG1000 User Manual

®
R&S EVSG1000
SETUP:BB_IN_RANGE?
SETUP:BB_IN_RANGE <Sensitvity>
Gets or sets sensitivity range for the baseband (LF In) input.
Parameters:
<Sensitvity>
Return values:
<State>

13.1.4 Result Display Settings

The following commands are required to configure the result displays for measure-
ments.
SETUP:UNIT:BARGRAPH?

SETUP:UNIT:BARGRAPH

SETUP:UNIT:DDM?
SETUP:UNIT:DDM
SETUP:UNIT:ILSPHASE?
SETUP:UNIT:ILSPHASE
SETUP:UNIT:LEVEL?
SETUP:UNIT:LEVEL
SETUP:UNIT:POLARITYDDM?
SETUP:UNIT:POLARITYDDM
SETUP:UNIT:SDM?
SETUP:UNIT:SDM
SETUP:UNIT:UPPERFREQ?
SETUP:UNIT:UPPERFREQ
SETUP:UNIT:VORDIRECTION?
SETUP:UNIT:VORDIRECTION
SETUP:UNIT:BARGRAPH?
SETUP:UNIT:BARGRAPH <MesDe>
This command sets the representation of bar graph.
Parameters:
<MesDe>
User Manual 1178.6227.02 ─ 04
100_MV
Sets 100 mV.
5V
Sets 5 V.
1V
Sets 1 V.
READY.
The command was executed successfully.
............................................................................................ 198
.............................................................................................. 198
....................................................................................................... 199
......................................................................................................... 199
...............................................................................................199
.................................................................................................199
.....................................................................................................199
...................................................................................................... 199
....................................................................................... 200
......................................................................................... 200
....................................................................................................... 200
......................................................................................................... 200
.......................................................................................... 201
............................................................................................ 201
......................................................................................201
........................................................................................201
ILSPHASE
Sets the MesDe parameter as ILSPHASE.
Cockpit
Sets the MesDe parameter as Cockpit.
Common Instrument and Measurement Setup
Remote Commands
198