5.4 Plug in the ALMEMO
! The data logger must be switched off.
1. Connect the peripherical devices to the ALMEMO
chapter 5.1 Connection of the Peripherals to the ALMEMO® clamping
connector).
2. Plug in the ALMEMO
the RTA6 slide-in module. In doing so pay attention to the port allocation of
your RTA6 slide-in module and connect the ALMEMO
to the ALMEMO
output).
3. Switch on the data logger (see Instruction Manual ALMEMO
5.5 Set the Port Assignment
If you want to set the port assignment via the interface and not via
the ALMEMO
®
ALMEMO
5.5.1 Open Port Settings
1. In the Home screen of the app, tap on the button
2. Tap on the arrow
3. Tap on the arrow
4. Tap on the arrow
5. Tap on the arrow
want to change the setting of a port.
6. Tap on the arrow
7. Tap on the arrow
®
clamping connector into the ALMEMO
®
socket with the appropriate port (relay/trigger/analog
®
500 app, see supplementary Instruction Manual
500 Transparent-Mode.
>
in the line
>
in the line of a measuring circuit board.
>
in the line
>
in the line of the RTA6 slide-in module , in which you
>
in the line
>
in the line of the port you want to set.
5 How to use the RTA6 Slide-in Module
®
Clamping Connector
Device list.
Output module.
Port list.
®
clamping connector (see
®
sockets on
®
clamping connector
®
500).
.
- 11 –