Dell PowerEdge R660xs Installation And Service Manual page 32

Table 34. 4 x 3.5-inch SAS/SATA Configuration with iDRAC
Dell PowerEdge Server Standard
Operating Support (ASHRAE A2
compliant) All options supported
unless otherwise noted.
not support thermal spec 70C optic
transceiver with power higher than
1.2W
● The following SAS drives could NOT
support in Rear storage module. (But
could support in front SM)
○ Kioxia PM6 SAS all capacities
○ SATA SSD, Hynix SE5031 all
capacities or thermal spec <70C
Table 35. 8 x 2.5-inch SAS3/SATA Configuration with iDRAC
Dell PowerEdge Server Standard
Operating Support (ASHRAE A2
compliant) All options supported
unless otherwise noted.
● STD Fan is required for CPU Base
TDP<=205W
● HPR Gold (VHP) Fan is required for
CPU Base TDP>205W
● STD HSK is required for CPU Base
TDP <=150W
● HPR HSK is required for CPU Base
TDP >150W
● 2-processor all configs or 1-processor
with Rear storage module config
requires 7x fans
● 1-processor without Rear storage
module config requires 5x fans
● HW restriction is required for CPU
Base TDP >225W
○ Front storage moduleonly support
4x2.5"SAS/SATA drives at
HDD#0~3, and HDD Bracket
GG6M3 x1 and M8KTX x1 are
required at empty HDD bay
● 100G PCIe and OCP3.0 NIC could
only support optic transceiver with
thermal Spec 85C and power
<=2.5W
● 25G PCIe NIC could only support
optic transceiver with thermal Spec
85C and power <=1.2W
● 25G OCP3.0 NIC with 4 ports or
PCIe cooling tier higher than 5 could
only support optic transceiver with
thermal spec 85C and power <=1.2W
● 25G OCP3.0 NIC with PCIe cooling
tier lower than or equal to 5 could
not support thermal spec 70C optic
transceiver with power higher than
1.2W
● The following SAS drives could NOT
support in Rear storage module. (But
could support in front storage)
32 Technical specifications
Dell PowerEdge Server Extended
Inletient 40° C Operating Support
(ASHRAE A3 compliant)
Dell PowerEdge Server Extended
Inletient 40° C Operating Support
(ASHRAE A3 compliant)
● Not support CPU Base TDP > 150W
● STD Fan is required.
● STD HSK is required
● Not support BOSS M.2 Module
● Not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Not support NIC consuming power
>= 25W.
● Not Support Config with Rear
storage module
● Not support OCP transfer rate >25G
or cooling tier > 10
● Optic Transceiver with spec 85C is
required
● Two PSUs are required. System
performance may be reduced in the
event of a PSU failure
Dell PowerEdge Server Extended
Inletient 45° C Operating Support
(ASHRAE A4 compliant)
Dell PowerEdge Server Extended
Inletient 45° C Operating Support
(ASHRAE A4 compliant)
● Not support