Running the Embedded System Diagnostics from the Dell Lifecycle
Controller
Steps
1. When the system is booting, press F10.
2. Select Hardware Diagnostics → Run Hardware Diagnostics.
The ePSA Pre-boot System Assessment window is displayed, listing all devices detected in the system. The diagnostics
start executing the tests on all the detected devices.
System diagnostic controls
Table 109. System diagnostic controls
Menu
Configuration
Results
System health
Event log
178
System diagnostics and indicator codes
Description
Displays the configuration and status information of all
detected devices.
Displays the results of all tests that are run.
Provides the current overview of the system performance.
Displays a time-stamped log of the results of all tests run on
the system. This is displayed if at least one event description
is recorded.